User's Manual

Chapter 1 Introducing the NWA
NWA-3500/NWA-3550 User’s Guide
35
The following table describes the behavior of the device LEDs.
LABEL LED COLOR STATUS DESCRIPTION
1 WL1 Green On The wireless adaptor WLAN1 is active.
Blinking The wireless adaptor WLAN1 is active, and
transmitting or receiving data.
Off The wireless adaptor WLAN1 is not active.
2 WDS/SYS Green On The NWA is in AP + Bridge or Bridge/
Repeater mode, and has successfully
established a Wireless Distribution System
(WDS) connection.
Red Flashing The NWA is starting up.
Off Either
The NWA is in Access Point or MBSSID mode
and is functioning normally.
The NWA is in AP + Bridge or Bridge/
Repeater mode and has not established a
Wireless Distribution System (WDS)
connection.
or
The NWA is not receiving power.
3 WL2 Green On The wireless adaptor WLAN2 is active.
Blinking The wireless adaptor WLAN2 is active, and
transmitting or receiving data.
Off The wireless adaptor WLAN2 is not active.
4 ZyAIR Blue On The NWA is receiving power.
You can turn the ZyAIR LED off and on using
the Web configurator. See Enable
Breathing LED in Section 8.3 on page 123.
Blinking The NWA is receiving power and
transmitting data to or receiving data from
its wireless stations.
Off Either
The NWA is not receiving power.
or
The ZyAIR LED has been disabled. See
Section 8.3 on page 123 for how to enable
the ZyAIR LED.