User's Manual

Chapter 8 Wireless Configuration
NWA-3500/NWA-3550 User’s Guide
130
Remote Bridge
MAC
Type the MAC address of the peer device in a valid MAC address
format, that is, six hexadecimal character pairs, for example,
12:34:56:78:9a:bc.
PSK Type a pre-shared key (PSK) from 8 to 63 case-sensitive ASCII
characters (including spaces and symbols). You must also set the
peer device to use the same pre-shared key. Each peer device can
use a different pre-shared key.
Enable Antenna
Diversity
Select this to use antenna diversity. Antenna diversity uses multiple
antennas to reduce signal interference.
Enable Breathing
LED
Select this box to disable the WLAN LED (light). Clear this box to
enable the WLAN LED.
Enable Spanning
Tree Control (STP)
(R)STP (Section 8.4.1 on page 139) detects and breaks network
loops and provides backup links between switches, bridges or
routers. It allows a bridge to interact with other (R)STP -compliant
bridges in your network to ensure that only one path exists between
any two stations on the network. Select the check box to activate
STP on the NWA.
Apply Click Apply to save your changes.
Reset Click Reset to begin configuring this screen afresh.
Table 24 Wireless: Bridge / Repeater
LABEL DESCRIPTIONS