User's Manual

Chapter 37 Diagnostic Manager
Vantage Access User’s Guide
569
Diagnostics Type Select the type of test you want to run on the selected device.
• IP Ping Diagnostics: select this to run a ping test on the device’s WAN.
• WAN DSL Diagnostics: select this to run a test on the device’s DSL
connection.
• WAN ATM F5 Loopback Diagnostics: select this to run a loopback
diagnostic (ping) test result on the ATM later.
• LAN IP Ping Diagnostics: select this to run a ping test on the device’s
LAN.
Test-specific information displays below.
• DiagnosticsState or LoopDiagnosticsState: this field is read-only and
displays Requested.
• Interface: enter the interface to test.
• Host: enter an IP address or hostname to test.
• NumberOfRepetitions: enter the number of times Vantage Access
should repeat the test.
• Timeout: enter the number of seconds Vantage Access waits before
cancelling the test.
• DataBlockSize:
• DSCP: Enter the DiffServ Control Point value (0~64) for this test.
Back Click this to return to the previous screen.
Table 334 Diagnostics Manager: Diagnostic Tests: Add
LABEL DESCRIPTION