User's Manual

Chapter 23 STB Service
Vantage Access User’s Guide
427
The following table describes the fields in this screen. Refer to Section 11.2.4 on page 132 for
other field descriptions.
23.3.13 Front End RTCP Setup
You can view and configure front end RTCP (RTP Control Protocol) settings in the RTCP
screen.
1 Select a registered device in the Device List window and click Data Model > Device >
Services > STBService.
2 Click a number and Components.
3 Click FrontEnd.
4 Click IP > RTCP to display the screen.
Figure 402 TR-135: STBService: Components: IP: RTCP
The following table describes the fields in this screen. Refer to Section 11.2.4 on page 132 for
other field descriptions.
23.3.14 Front End RTP AVPF Setup
You can view and configure front end RTP AVPF settings in the RTPAVPF screen.
1 Select a registered device in the Device List window and click Data Model > Device >
Services > STBService.
2 Click a number and Components.
3 Click FrontEnd.
Table 233 TR-135: STBService: Components: IP
PARAMETER NAME VALUE
InboundNumberOfEnt
ries
This displays the number of inbound instances.
OutboundNumberOfE
ntries
This displays the number of outbound instances.
ActiveInbounds This displays the number of active inbound streams.
ActiveOutbounds This displays the number of active outbound streams.
Table 234 TR-135: STBService: Components: IP: RTCP
PARAMETER NAME VALUE
Enable This displays whether RTCP receiver report generation is enabled.
Status This displays the status of RTCP receiver report generation.
TxRepeatInterval This displays the transmission repeat interval in milliseconds.