User's Manual

Chapter 23 STB Service
Vantage Access User’s Guide
411
23.2.9 MPEG4 Part 2 Setup
You can view and configure MPEG4 Part 2 settings in the MPEG2Part2 screen. This screen
displays the supported MPEG4 profiles. It also displays the set of audio standards supported
when MPEG4 Part 2 is used.
1 Select a registered device in the Device List window and click Data Model > Device >
Services > STBService.
2 Click a number and Capabilities.
3 Click Video Decoder > MPEG4Part2 to display the screen.
Figure 374 TR-135: STBService: Capabilities: MPEG4Part2
The following table describes the fields in this screen. Refer to Section 11.2.4 on page 132 for
other field descriptions.
23.2.10 MPEG4 Part 2 Profile Levels
You can view and configure MPEG4 Part 2 Profile Levels in the ProfileLevel screen.
1 Select a registered device in the Device List window and click Data Model > Device >
Services > STBService.
2 Click a number and Capabilities.
3 Click Video Decoder > MPEG4Part2 > ProfileLevel to display the screen.
Figure 375 TR-135: STBService: Capabilities: MPEG4Part2 ProfileLevel
23.2.11 MPEG4 Part 2 Profile Level Settings
You can view and configure each MPEG4 Part 2 profile and level. Each is a combination of
profile and level.
Table 212 TR-135: STBService: Capabilities: MPEG4Part2
PARAMETER NAME VALUE
AudioStandards This displays the MPEG4 Part 2 audio standards supported by the STB.
ProfileLevelNumberOf
Entries
This displays the number of profile levels.