User's Manual

Chapter 22 Voice Service
Vantage Access User’s Guide
372
22.9 Voice Profile RTP Setup
Use the RTP screen to configure RTP (Real Time Protocol) settings for sending voice traffic
on the device.
1 Select a registered device in the Device List window and click Data Model > Device >
Services > VoiceService.
2 Click a number and VoiceProfile.
3 Click a number and RTP to display the configuration screen.
Figure 320 TR-104: VoiceService: VoiceProfile: RTP
The following table describes the fields in this screen. Refer to Section 11.2.4 on page 132 for
other field descriptions.
22.9.1 Voice Profile RTCP Setup
Use the RTCP screen to configure RTCP (Real-time Transport Control Protocol) settings for
sending voice traffic on the device.
1 Select a registered device in the Device List window and click Data Model > Device >
Services > VoiceService.
VLANIDMark This field displays the IEEE 802.1Q VLAN ID the device adds to outgoing
H.323 signalling packets.
EthernetPriorityMark This field displays the IEEE 802.p priority level the device adds to outgoing
H.323 signalling packets.
Table 176 TR-104: VoiceService: VoiceProfile: H.323 (continued)
PARAMETER NAME VALUE
Table 177 TR-104: VoiceService: VoiceProfile: RTP
PARAMETER NAME VALUE
LocalPortMin This field displays the start of the local port range for incoming voice traffic.
LocalPortMax This field displays the end of the local port range for incoming voice traffic.
DSCPMark This field displays the DiffServ code number for the outgoing voice traffic.
VLANIDMark This field displays the VLAN ID to use for the outgoing voice traffic.
EnthernetPriorityMark This field displays the IEEE 802.1D priority level to use for the outgoing voice
traffic.
TelephoneEventPaylo
adType
This field displays the traffic type for the RTF telephone event.