User's Manual

Chapter 22 Voice Service
Vantage Access User’s Guide
370
22.7 MGCP
Use the MGCP screen to view and configure settings for the MGCP call agent(s) for the
profile.
1 Select a registered device in the Device List window and click Data Model > Device >
Services > VoiceService.
2 Click a number and VoiceProfile.
3 Click a number and MGCP.
Figure 318 TR-104: VoiceService: VoiceProfile: MGCP
The following table describes the fields in this screen. Refer to Section 11.2.4 on page 132 for
other field descriptions.
Table 175 TR-104: VoiceService: VoiceProfile: MGCP
PARAMETER NAME VALUE
CallAgent1 .. 2 This field displays the host name or the IP address of the MSCP call agent.
CallAgentPort1 .. 2 This field displays the destination port to use to connect to the MSCP call
agent.
RetranIntervalTimer This field displays the time interval (in milliseconds) the device is to wait
before sending the message again.
MaxRetranCount This field displays the maximum number of times the device is to resend a
message.
RegisterMode This field displays the registration mode.
LocalPort This field displays the listening port number for incoming call control
signalling.
Domain This field displays the name of the domain to which the device belongs.
User This field displays the user name used to access the call agent.
DSCPMark This field displays the DiffServ Code Point the device adds to outgoing
MGCP signalling packets.
VLANIDMark This field displays the IEEE 802.1Q VLAN ID the device adds to outgoing
MGCP signalling packets.