User's Manual

Chapter 21 WAN Device
Vantage Access User’s Guide
351
21.14.2 Port Mapping Table
Use the PortMapping screen to view the port mapping instance for the WAN PPP connection.
Refer to Section 11.2.4 on page 132 for other field descriptions.
1 Select a registered device in the Device List window and click Data Model >
InternetGatewayDevice > WANDevice.
2 Click a number and WANConnectionDevice.
3 Click a number and WANPPPConnection.
4 Click a number and PortMapping to display the screen as shown.
Figure 298 TR-098 Amendment 1: WAN Device: WANPPPConnection: PortMapping
21.14.3 Port Mapping Table Details
Use the detailed PortMapping screen to configure the port mapping settings for the WAN
PPP connection.
1 Select a registered device in the Device List window and click Data Model >
InternetGatewayDevice > WANDevice.
2 Click a number and WANConnectionDevice.
3 Click a number and WANPPPConnection.
4 Click a number and PortMapping.
5 Click a number to display the screen as shown.
RouteProtocolRx This field displays the routing protocol (RIP1, RIP2 or OSPF) the link is to
use.
Off disables the routing feature.
PPPLCPEcho This field displays the time (in seconds) for PPP Link Control Protocol
(LCP) echo.
PPPLCPEchoRetry This field displays the time (in seconds) for PPP Link Control Protocol
(LCP) echo retry.
ShapingRate This field displays the rate (in bits per second) the device shapes the
outgoing traffic to.
ShapingBurstSize This field displays the burst size (in bytes) for traffic shaping.
PortMappingNumberOfE
ntries
This field displays the number of port mappings on this link.
Table 163 TR-098 Amendment 1: WAN Device: WANPPPConnection: Details (continued)
PARAMETER NAME VALUE