User's Manual

Chapter 19 General Device Setup
Vantage Access User’s Guide
287
Click Data Model > InternetGatewayDevice > Layer3Forwarding > Forwarding.
Figure 226 TR-098 Amendment 1: Layer3 Forwarding Table
19.9.2 Layer3 Forwarding Table Details
Use the detailed Forwarding screen to configure the layer 3 forwarding table on the device.
Select a registered device in the Device List window and click Provision > Data Model >
InternetGatewayDevice > Layer3Forwarding > Forwarding. Then click on an index
number.
Figure 227 TR-098 Amendment 1: Layer3 Forwarding Table: Details
The following table describes the labels in this screen. Refer to Section 11.2.4 on page 132 for
other field descriptions.
Table 124 TR-098 Amendment 1: Layer3 Forwarding: Forwarding
PARAMETER
NAME
VALUE
Enable This field displays 1 to indicate that entry in the forwarding table is enabled.
A value of 0 means that the rule is disabled. This is the default setting for new
forwarding entries.
Status This field displays the status of the forwarding entry.
Type This field displays the route type.
Default sets the device to route packets with any destination.
Host sets the device to route packets to a specific destination IP address.
Network sets the device to route packets to an IP network.
DestIPAddress This field displays the destination IP address in dotted decimal notation for the
route entry.
DestSubnetMask This field displays the destination subnet mask in dotted decimal notation for
the route entry.
SourceIPAddress This field displays the source IP address in dotted decimal notation for the route
entry.