User's Manual

ZyAIR B-2000 Wireless LAN Gateway with 4-Port Switch
Internet Access 3-9
Figure 3-6 Menu 3.2.1-IP Alias Setup
Follow the instructions in the table below to configure IP Alias parameters.
Table 3-3 IP Alias Setup Menu Fields
FIELD DESCRIPTION EXAMPLE
IP Alias
Choose Yes to configure the LAN network for the ZyAIR. Yes
IP Address Enter the IP address of your ZyAIR in dotted decimal notation 192.168.1.1
IP Subnet Mask Your ZyAIR will automatically calculate the subnet mask based on
the IP address that you assign. Unless you are implementing
subnetting, use the subnet mask computed by the ZyAIR
255.255.255.0
RIP Direction
Press [SPACE BAR] to select the RIP direction. Choices are None,
Both, In Only or Out Only.
None
Version
Press [SPACE BAR] to select the RIP version. Choices are RIP-1,
RIP-2B or RIP-2M.
RIP-1
Incoming
Protocol Filters
Enter the filter set(s) you wish to apply to the incoming traffic
between this node and the ZyAIR.
Outgoing
Protocol Filters
Enter the filter set(s) you wish to apply to the outgoing traffic between
this node and the ZyAIR.
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm…” to save
your configuration, or press [
ESC] at any time to cancel.
Menu 3.2.1 - IP Alias Setup
IP Alias 1= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
IP Alias 2= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
Enter here to CONFIRM or ESC to CANCEL: