User's Manual

ZyAIR B-2000 Wireless LAN Gateway with 4-Port Switch
Internet Access 3-7
Table 3-1 DHCP Ethernet Setup Menu Fields
FIELD DESCRIPTION EXAMPLE
Remote DHCP
Server
If Relay is selected in the DHCP field above then enter the IP
address of the actual remote DHCP server here.
Follow the instructions in the following table to configure TCP/IP parameters for the Ethernet port.
Table 3-2 TCP/IP Ethernet Setup Menu Fields
FIELD DESCRIPTION EXAMPLE
TCP/IP Setup
IP Address Enter the (LAN) IP address of your ZyAIR in dotted decimal notation 192.168.1.1
IP Subnet Mask Your ZyAIR will automatically calculate the subnet mask based on the
IP address that you assign. Unless you are implementing subnetting,
use the subnet mask computed by the ZyAIR.
255.255.255.0
RIP Direction
Press [
SPACE BAR] to select the RIP direction. Choices are Both, In
Only, Out Only or None.
Both
(default)
Version
Press [SPACE BAR] to select the RIP version. Choices are RIP-1,
RIP-2B or RIP-2M.
RIP-1
(default)
Multicast IGMP (Internet Group Multicast Protocol) is a session-layer protocol
used to establish membership in a Multicast group. The ZyAIR supports
both IGMP version 1(IGMP-v1) and version 2 (IGMP-v2). Press the
[
SPACE BAR] to enable IP Multicasting or select None to disable it.
None
(default)
Edit IP Alias The ZyAIR supports three logical LAN interfaces via its single physical
Ethernet interface with the ZyAIR itself as the gateway for each LAN
network.
Press [
SPACE BAR] to select Yes and press [ENTER] to go to menu
3.2.1
No
(default)
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm…” to save
your configuration, or press [ESC] at any time to cancel.
3.6 IP Alias
IP Alias allows you to partition a physical network into different logical networks over the same Ethernet
interface. The ZyAIR supports three logical LAN interfaces via its single physical Ethernet interface with
the ZyAIR itself as the gateway for each LAN network.