User's Manual

ZyAIR B-2000 Wireless LAN Gateway with 4-Port Switch
2-6 Hardware Installation and Initial Setup
2.5 ZyAIR Configuration
Configure your ZyAIR using:
 Web configurator
 SMT (System Management Terminal). Access the SMT via:
o LAN or WAN using Telnet
o Console port using terminal emulation software
2.5.1 Connect to Your ZyAIR Using the Web Configurator
Step 1. Make sure your computer IP address and the ZyAIR IP address are on the same subnet. Refer to
the TCP/IP appendix.
Step 2. Launch your web browser and enter 192.168.1.1 as the URL.
Step 3. In the Password field, type "1234". Click Login.
Step 4. Either enter a new password (and retype it to confirm) and click Apply or click Ignore.
Click the Help button for online web configurator HTML help.
2.5.2 Connect to your ZyAIR Using Telnet
The following procedure details how to telnet into your ZyAIR.
Step 1. Make sure your computer IP address and the ZyAIR IP address are on the same subnet. Refer to
the TCP/IP appendix.
Step 2. In Windows, click Start (usually in the bottom left corner), Run and then type “telnet
192.168.1.1” (the default IP address) and click OK.
Step 3. Enter 1234 in the Password field.
Step 4. After entering the password you will see the main menu.
2.5.3 Connect to Your ZyAIR Using the Console Port
Step 1. Connect the 7-pin male end of a console port cable to the port labelled CONSOLE on the
ZyAIR and the 9-pin female end to an avaliable serial port on your computer.
Step 2. Run the communications software and configure the communication parameteres as described
in the Additional Installation Requirements section.
Step 3. Turn on your ZyAIR and you should see the initial screen shown next.