Owners manual

Chapter 1 Introduction
NWA5000 / WAC6500 Series User’s Guide
24
The following are the LED descriptions for your NWA5301-NJ.
1.6.3 NWA5121-N, NWA5121-NI, and NWA5123-NI
The following are the LED descriptions for your NWA512x.
Table 7 NWA5301-NJ LEDs
LABEL COLOR STATUS DESCRIPTION
PWR/SYS Amber Slow Blinking
(On for 1s,
Off for 1s)
The NWA is booting up.
Green On
Amber Off The NWA is ready for use.
Green On
Amber Slow Blinking
(blink for 3
times, Off for
3s)
The NWA is discovering an AP controller
Green On
Amber On The NWA failed to boot up or is experiencing system failure.
Green Off
Amber Fast Blinking
(On for 50ms
times, Off for
50ms)
The NWA is undergoing firmware upgrade.
Green Off
Amber Slow Blinking
(blink for 3
times, Off for
3s)
Uplink is disconnected.
Green Off
Amber Slow Blinking
(blink for 2
times, Off for
3s)
The wireless module of the WAC is disabled or failed.
Green Off
PoE Green On Power is supplied to the yellow PoE Ethernet port (LAN1).
Off There is no power supply.
WLAN Green On The WLAN is active.
Blinking The WLAN is transmitting or receiving data.
Off The WLAN is not active.
UPLINK Green On The port is connected.
Blinking The NWA/WAC is sending/receiving data through the port.
Off The port is not connected.
LAN1-3 Green On The port is connected.
Blinking The NWA/WAC is sending/receiving data through the port.
Off The port is not connected.