Owners manual

Chapter 1 Introduction
NWA5000 / WAC6500 Series User’s Guide
22
The following table describes the LEDs.
Table 6 WAC LEDs
LED COLOR STATUS DESCRIPTION
PWR/SYS Red Slow
Blinking
(On for 1s,
Off for 1s)
The WAC is booting up.
Green On
Red Off The WAC is ready for use.
Green On
Red On There is system error and the WAC cannot boot up, or the
WAC suffered a system failure.
Green Off
Red Fast
Blinking (on
for 50ms,
Off for
50ms)
The WAC is doing firmware upgrade.
Green Off
Red Slow
Blinking
(blink for 3
times, Off
for 3s)
The Uplink is disconnected.
Green Off
Red Slow
Blinking
(blink for 2
times, Off
for 3s)
The wireless module of the WAC is disabled or failed.
Green Off
Management Green On The WAC AP is managed by a controller.
Blinking The WAC AP is searching (discovery) for a controller.
Off The WAC AP is in standalone mode.
WLAN Green On The 2.4 GHz WLAN is active.
Blinking The 2.4 GHz WLAN is transmitting or receiving data.
Off The 2.4 GHz WLAN is not active.
WLAN Green On The 5 GHz WLAN is active.
Blinking The 5 GHz WLAN is transmitting or receiving data.
Off The 5 GHz WLAN is not active.
UPLINK Amber/Green On Amber - The port is operating as a 100-Mbps connection.
Green - The port is operating as a Gigabit connection (1000
Mbps).
Blinking The WAC is sending/receiving data through the port.
Off The port is not connected.