User's Manual

VSG-1200 User’s Guide
Chapter 26 The SMT 203
26.6 Changing the System Password
Follow the steps below to change the system password.
1 In the main menu, type 5 and press [ENTER] to display the Utilities menu.
2 In the Utilities menu, type 2 and press [ENTER]. The Change Administrator Password
menu displays.
Figure 140 SMT: Change Administrator Password
3 Type your current system password in the Enter the old password field, and press
[ENTER].
Web Server Port Specify the port number of the embedded web server on the VSG to access the
web configurator. The default port number is 80.
Enter a number between 8010 and 8060 to access the web configurator behind a
NAT-enabled network.
If you enter a number between 8010 and 8060, you need to append the port
number to the WAN or LAN port IP address to access the web configurator. For
example, if you enter “8010” as the web server port number, then you must enter
“http://www.192.168.1.1:8010” where 192.168.1.1 is the WAN or LAN port IP
address.
E-mail Server
Redirect
Enter the IP address or domain name of the e-mail server to which the VSG
forwards e-mail. This field should be configured if the e-mail server is behind a
firewall or on a NAT-enabled network.
At the “S)ave and return R)eturn without saving M)odify:” prompt, type S and press [ENTER] to save the
changes and return to the previous screen, type R and press [ENTER] to discard all changes and return
to the previous screen or type M and press [ENTER] to continue configuring the fields. Restart the
device when prompted
Press [ESC] and enter Y to stop any actions in the current screen and return to the previous screen. All
changes will be discarded.
Table 68 SMT: System Configuration (continued)
FIELD DESCRIPTION
Note: It is recommended you change the default system password.
Change Administrator Password
Enter the old password :
Enter the new password :
Confirm the new password: