User Manual
Table Of Contents
- ARMOR G5
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG7815 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG7815’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG7815’s LED (Light)
- 7.9 Change Your NBG7815 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 9 WAN
NBG7815 User’s Guide
98
Use this screen to enable UPnP on your NBG7815. Click Settings > Internet > UPnP to display the following
screen.
Figure 53 Settings > Internet > UPnP
9.9.1 Turning On UPnP in Windows 7 Example
This section shows you how to use the UPnP feature in Windows 7. UPnP server is installed in Windows 7.
Activate UPnP on the NBG7815 in Settings > Internet > UPnP.
Make sure the computer is connected to a LAN port of the NBG7815. Turn on your computer and the
NBG7815.
1 Click the start icon, Control Panel and then the Network and Sharing Center.
Table 31 Settings > Internet > UPnP
LABEL DESCRIPTION
UPnP Setup
Enable UPnP Select Enable to activate UPnP.
Be aware that anyone could use a UPnP application to open the web configurator's
login screen without entering the NBG7815's IP address (although you must still enter
the password to access the web configurator).
UPnP Setup Rule
No. This is the number of an individual UPnP entry.
Protocol This is the transport layer protocol used for the service.
InPort InPort is a port that a LAN computer uses when it requests a particular service. This
port is only applicable to the local network.
This field displays the port number of the UPnP entry.
OutPort OutPort is the well-known port that the WAN server uses to reply to the LAN computer
that made the request using In Port.
This field displays the port number of the UPnP entry.
IP Address This field displays the IP address of this UPnP entry.
Apply Click Apply to save your settings.
Cancel Click Cancel to return to the previously saved settings.