User Manual
Table Of Contents
- ARMOR G5
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG7815 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG7815’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG7815’s LED (Light)
- 7.9 Change Your NBG7815 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 8 Applications
NBG7815 User’s Guide
67
8.3.3.1 OpenVPN Server List-Add Rule Screen
Use this screen to add an OpenVPN Server Account that you want your NBG7815 to connect to.
Figure 30 OpenVPN Server List-Add Rule
The following table describes the fields in this screen.
Active Slide the switch to the right ( ) to activate your connection to an OpenVPN
Server account.
Actions Click the icons under Actions to delete or edit an existing OpenVPN Server account
settings.
Click to delete an existing OpenVPN Server account.
Click to edit an existing OpenVPN Server account.
Table 15 OpenVPN Client
LABEL DESCRIPTION
Table 16 OpenVPN Server List-Add Rule
LABEL DESCRIPTION
Description Enter 1-32 single-byte printable ASCII characters, but <>^$& are not allowed.
User Name Enter the User Name of the OpenVPN Server account you want to connect to.
Password Enter the Password of the OpenVPN Server account you want to connect to.
Import .ovpn file Import an .ovpn file that you get from the OpenVPN Server that you want to
connect to.
Note: Do not import the .ovpn file you get from your NBG7815’s OpenVPN
Server.
Enable VPN on Select the interface(s) that are allowed by the OpenVPN Server account you want
to connect to.