User Manual
Table Of Contents
- ARMOR G5
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG7815 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG7815’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG7815’s LED (Light)
- 7.9 Change Your NBG7815 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 8 Applications
NBG7815 User’s Guide
63
Figure 24 Example of NBG7815 Acting As VPN Server
Note: You have to enable DDNS in Settings > Internet > Dynamic DNS screen before you can
create an OpenVPN account. See Section 9.8 on page 96 for more information on
Dynamic DNS.
Figure 25 OpenVPN Server
The following table describes the fields in this screen.
Table 12 OpenVPN Server
LABEL DESCRIPTION
OpenVPN Server
Dynamic DNS This field shows the status of your Dynamic DNS. Make sure it shows Enable before
you create an OpenVPN account.
Host Name This field shows the Host Name of your Dynamic DNS account.
Configuration
Status Select Enable to activate your OpenVPN Server account.
Protocol Select the protocol you want to apply to your OpenVPN Server account.