User Manual
Table Of Contents
- ARMOR G5
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG7815 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG7815’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG7815’s LED (Light)
- 7.9 Change Your NBG7815 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 8 Applications
NBG7815 User’s Guide
62
8.2.1.3 Profile Screen
Use this screen to edit or delete an existing rule. Click Parental Control > Profile to show the following
screen.
Figure 23 Parental Control > Profile
The following table describes the fields in this screen.
8.3 OpenVPN Server/Client
OpenVPN is a VPN protocol which is open source and free of charge. It can be used to create a virtual
private network or to interconnect local networks.
It uses OpenSSL encryption library and SSLv3/TLSv1 protocols. This provides high security and anonymity
for all transmitted data.
It also provides faster connection speeds than other VPN protocols.
Note: We do not recommended activating OpenVPN Server and OpenVPN Client at the
same time on your NBG7815.
Note: This is not available if you are using bridge mode.
8.3.1 OpenVPN Server Screen
Use this screen to create an OpenVPN server account. Click the Navigation Panel icon on the top-left
corner ( ).Select OpenVPN Server, and click the OpenVPN Server tab.
Table 11 Parental Control > Profile
LABEL DESCRIPTION
Enable/Disable Set the switch to the right ( ) to enable an existing rule. Otherwise, set the
switch to the left ( ).
Quick Block Click Quick Block to activate the profile.
Edit Click on the Edit icon to edit an existing rule.
Delete Click on the Delete icon to delete an existing rule.