User Manual
Table Of Contents
- ARMOR G5
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG7815 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG7815’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG7815’s LED (Light)
- 7.9 Change Your NBG7815 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 13 System
NBG7815 User’s Guide
135
Figure 77 Settings > System > Status (Bridge Mode)
The following table describes the labels in this screen.
Table 46 Settings > System > Status
LABEL DESCRIPTION
System
Model Name This is the model name of your device.
Firmware Version This is the firmware version.
System Operation Mode This is the device mode in which the NBG7815 is currently running. See Section 13.7
on page 140 for more information.
Enable IPv4 Firewall This shows if the IPv4 firewall is enabled on the NBG7815.
Enable IPv6 Simple Security This shows if the IPv6 firewall is enabled on the NBG7815.
System Uptime This is the total time the NBG7815 has been on.
WAN Information
Note: : This is not available if you are using bridge mode.
MAC Address This shows the WAN Ethernet adapter MAC Address of your device.
IP Address This shows the NBG7815’s WAN IP address.
IP Subnet Mask This shows the NBG7815’s WAN subnet mask.
Gateway This shows the WAN port’s gateway IP address.
IPv6 Address This shows the current IPv6 address of the NBG7815.
LAN Information
MAC Address This shows the LAN Ethernet adapter MAC Address of your device.
IP Address This shows the NBG7815’s LAN IP address.
IP Subnet Mask This shows the NBG7815’s LAN subnet mask.