User Manual
Table Of Contents
- ARMOR G5
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG7815 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG7815’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG7815’s LED (Light)
- 7.9 Change Your NBG7815 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 12 Security
NBG7815 User’s Guide
132
Figure 75 Settings > Firewall > IPv6 Firewall > Add Rule
The following table describes the labels in this screen.
Table 45 Settings > Firewall > IPv4 Firewall > Add Rule
LABEL DESCRIPTION
Service Name Enter a name that identifies or describes the firewall rule.
MAC Address Enter the MAC address of the computer for which the firewall rule applies.
Dest IP Address Enter the IP address of the computer to which traffic for the application or service is
entering.
The NBG7815 applies the firewall rule to traffic initiating from this computer.
Source IP Address Enter the IP address of the computer that initializes traffic for the application or
service.
The NBG7815 applies the firewall rule to traffic initiating from this computer.
Dest Port Range This is the port number/range of the destination that define the traffic type, for
example TCP port 80 defines web traffic.
Source Port Range This is the port number/range of the source that define the traffic type, for example
TCP port 80 defines web traffic.
Protocol Select the protocol (TCP, UDP or ICMP) used to transport the packets for which you
want to apply the firewall rule.
Apply Click Apply to save the settings.
Cancel Click Cancel to exist this screen without saving.