User Manual
Table Of Contents
- ARMOR G5
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG7815 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG7815’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG7815’s LED (Light)
- 7.9 Change Your NBG7815 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 10 Wireless LAN
NBG7815 User’s Guide
114
Figure 61 Settings > WiFi > WPS
The following table describes the labels in this screen.
Table 36 Settings > WiFi > WPS
LABEL DESCRIPTION
WPS
WiFi WPS Status Select Enable to turn on the WPS feature. Otherwise, select Disable.
Push Button Use this button when you use the PBC (Push Button Configuration) method.
Click this to start WPS-aware wireless station scanning and wireless security information
synchronization.
WPS Status
Status This displays Configured when a wireless station has connected to the NBG7815 using WPS
and wireless setup or security settings have been changed from default. The current wireless
setup and security settings also appear in this screen.
This displays Unconfigured if WPS is disabled and there are no wireless setup or security
changes on the NBG7815 or if you click Release Configuration to restore wireless setup and
security settings to default.
802.11 Mode This is the 802.11 mode used. Only compliant WLAN devices can associate with the
NBG7815.
SSID This is the name of the wireless network (the NBG7815’s first SSID) that WPS clients connect to.
Security This is the type of wireless security employed by the network.
Apply Click Apply to save your changes back to the NBG7815.
Cancel Click Cancel to reload the previous configuration for this screen.