User Manual
Table Of Contents
- ARMOR G1
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG6818 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG6818’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG6818’s LED (Light)
- 7.9 Change Your NBG6818 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 9 WAN
NBG6818 User’s Guide
86
The following table describes the labels in this screen.
Table 24 Network > WAN > Internet Connection: PPTP Encapsulation
LABEL DESCRIPTION
Internet Connection
Internet Service
Provider Type
Select PPTP if you want to connect the Internet via point to point tunneling protocol.
PPTP Username Enter the user name given to you by your ISP.
Password Enter the password associated with the user name above.
PPTP Encryption Type Use the drop-down list box to select the type of Microsoft Point-to-Point Encryption (MPPE).
Options are:
Auto - This ISP account adjusts the encryption type automatically.
None - This ISP account does not use MPPE.
40 - This ISP account uses 40-bit MPPE.
128 - This ISP account uses 128-bit MMPE.
MTU Size Enter the MTU (Maximum Transmission Unit) size for each packet. If a larger packet arrives,
the NBG6818 divides it into smaller fragments.
PPTP Server IP
Address
Enter the IP address of the PPTP server.
Auto Connect Select this radio button if the PPTP server did not assign you a fixed IP address.
Static IP Select this radio button if the PPTP server assigned an IP address for your Internet
connection.
IP Address Enter the IP address provided by the PPTP server.
IP Subnet Mask Enter the IP subnet mask in this field.
Gateway Enter the gateway IP address in this field.
DNS Server
First DNS Server
Second DNS Server
Third DNS Server
Select User-Defined if you have the IP address of a DNS server. Enter the DNS server's IP
address in the field to the right.
Select None if you do not want to configure DNS servers. If you do not configure a DNS
server, you must know the IP address of a computer in order to access it.
WAN IP Address Assignment
Obtained from ISP Select this option If your ISP did not assign you a fixed IP address. This is the default selection.
Fixed IP Select this option If the ISP assigned a fixed IP address.
IP Address Enter your WAN IP address in this field if you selected IP Address.
WAN MAC Address
Once the WAN MAC address is successfully configured, the address will be copied to the configuration file. It will
not change unless you change the setting or upload a different configuration file.
Factory Default Select this option to have the WAN interface use the factory assigned default MAC address.
By default, the NBG6818 uses the factory assigned MAC address to identify itself.
Clone My
Computer’s MAC
Address
Select this option to have the WAN interface use a different MAC address by cloning the
MAC address of another device or computer. Enter the IP address of the device or
computer whose MAC you are cloning.
Set WAN MAC
Address
Select this option to have the WAN interface use a manually specified MAC address. Enter
the MAC address in the fields.
LAN & WAN Subnet Conflict