User Manual
Table Of Contents
- ARMOR G1
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG6818 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG6818’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG6818’s LED (Light)
- 7.9 Change Your NBG6818 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 8 Applications
NBG6818 User’s Guide
74
Figure 37 USB1
Once you access usb1 via your NBG6818, you do not have to relogin unless you restart your computer.
8.5.2 Using FTP Program
Here is how to use an FTP program to access a file storage device connected to the NBG6818’s USB
port.
Note: This example uses the FileZilla FTP program to browse your shared files.
1 Download FileZilla and install the FTP software to your computer
2 Go to USB Application > FTP. On the FTP Setup screen, click Add Rule to go to the Add FTP Account
screen. You can use this screen to create a set of User Name and Password and set up USB rules for file
sharing. (See more information at Section 8.4.2 on page 69.) Click Apply to save the changes.
Figure 38 Add FTP Account