User Manual
Table Of Contents
- ARMOR G1
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG6818 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG6818’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG6818’s LED (Light)
- 7.9 Change Your NBG6818 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 8 Applications
NBG6818 User’s Guide
63
8.3.2 OpenVPN Account Screen
Use the OpenVPN Account List screen to view the basic information of the NBG6818 OpenVPN server.
Use the OpenVPN Account Status screen to view the basic information of clients that are connected to
the NBG6818 OpenVPN server
Note: At the time of writing, up to 16 OpenVPN clients can connect to the NBG6818
OpenVPN server at the same time.
Figure 26 OpenVPN Account
Server Port The default server port number is 1194. You can change it if needed. However,
clients connected to this OpenVPN Server account will have to use the same port
number in order to access the server account.
VPN Subnet/ Netmask The fields define the network form which OpenVPN clients can connect to the
NBG6818 OpenVPN server.
Enter an IPv4 address and subnet mask.
Advertise DNS to Clients Select Enable if you want the NBG6818 to broadcast its OpenVPN server to
OpenVPN clients in its VPN network defined previously.
Key Setting Click the Change Key button if you want to change the key your clients use to
access to your OpenVPN Server account.
You do not need to click Change Key the first time to configure this screen.
Periodically changing the key is recommended, but you must export the new .opvn
configuration file and send it to all OpenVPN clients so that they can they use the
new key.
Export Config Click Export Config to export your configuration to an .ovpn file that OpenVPN
clients need to connect to the NBG6818 OpenVPN server.
Apply Click Apply to save your changes back to the NBG6818.
Cancel Click Cancel to begin configuring this screen afresh.
Table 12 OpenVPN Server
LABEL DESCRIPTION