User Manual
Table Of Contents
- ARMOR G1
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG6818 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG6818’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG6818’s LED (Light)
- 7.9 Change Your NBG6818 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 8 Applications
NBG6818 User’s Guide
59
Figure 21 Edit Device Detail
8.2.1.2 Add New Profile Screen
Use this screen to configure a restricted access schedule. Click the Action icon (), then Add New
Profile to show the following screen.
Table 9 Edit Device Detail
LABEL DESCRIPTION
Device Name Enter a name for the device to which this rule applies.
Type Choose the type of device to which this rule applies.
Apply Click Apply to save your settings back to the NBG6818.
Cancel Click Cancel to exist the screen without saving.