User Manual
Table Of Contents
- ARMOR G1
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG6818 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG6818’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG6818’s LED (Light)
- 7.9 Change Your NBG6818 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 7 Tutorials
NBG6818 User’s Guide
51
7.9 Change Your NBG6818 Operating Mode
The operating mode refers to how the NBG6818 is being used in the network. The NBG6818 has two
operating modes:
• Standard: This is the NBG6818’s default mode. In this mode, the NBG6818 routes traffic between a
local network and another network such as the Internet.
• Bridge: Use this mode so the NBG6818 bridges traffic between clients on the same network.
Note: Features such as parental Control, UPnP, Port Forwarding are not available in Bridge
mode.
1 Click the Navigation Panel icon on the top-left corner ( ).From the Settings drop-down list, click
System, then click the Operating Mode tab. Select the operating mode and select APPLY to save your
changes. Changing the NBG6818’s operating mode may take up to two minutes.