User Manual
Table Of Contents
- ARMOR G1
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG6818 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG6818’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG6818’s LED (Light)
- 7.9 Change Your NBG6818 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 5 Standard Mode
NBG6818 User’s Guide
36
CHAPTER 5
Standard Mode
5.1 Overview
The NBG6818 is set to standard (router) mode by default. Routers are used to connect the local network
to another network (for example, the Internet). In the figure below, the NBG6818 connects the local
network (LAN1 ~ LAN4) to the Internet.
Figure 14 NBG6818 in Standard Mode
5.2 What You Can Do
• Use the Status screen to view read-only information about your NBG6818 (Section 5.3 on page 36).
5.3 Standard Mode Status Screen
Click Settings > System > Status to open the status screen.