User Manual
Table Of Contents
- ARMOR G1
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG6818 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG6818’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG6818’s LED (Light)
- 7.9 Change Your NBG6818 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 4 NBG6818 Modes
NBG6818 User’s Guide
34
CHAPTER 4
NBG6818 Modes
4.1 Overview
This chapter introduces the different operating modes available on your NBG6818. Or simply how the
NBG6818 is being used in the network.
4.2 Modes
This refers to the operating mode of the NBG6818, which can act in:
• Standard Mode: This is the default device mode of the NBG6818. Use this mode to connect the local
network to another network, like the Internet. Go to Section 5.3 on page 36 to view the Status screen
in this mode.
Figure 12 Standard Mode Example
• Bridge Mode: Use this mode if you want to extend your network by allowing network devices to
connect to the NBG6818 wirelessly. Go to Section 6.4 on page 41 to view the Status screen in this
mode.