User Manual
Table Of Contents
- ARMOR G1
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG6818 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG6818’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG6818’s LED (Light)
- 7.9 Change Your NBG6818 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 13 System
NBG6818 User’s Guide
133
13.4 General Setting Screen
Use this screen to set the management session timeout period. Click Settings > System > General Setting
to show the following screen.
Figure 79 Settings > System > General Setting (Standard Mode)
DHCP Server This shows whether the NBG6818 acts as a DHCP Server and provides LAN IP
addresses to its clients or not.
IPv6 Address This shows the current LAN IPv6 address of the NBG6818.
Table 46 Settings > System > Status (continued)
LABEL DESCRIPTION