User Manual
Table Of Contents
- ARMOR G1
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG6818 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG6818’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG6818’s LED (Light)
- 7.9 Change Your NBG6818 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 11 LAN
NBG6818 User’s Guide
118
Figure 68 Settings > LAN > LAN IP > Add Rule
Figure 69 Settings > LAN > LAN IP > Edit
The following table describes the labels in these screens.
Table 39 Settings > LAN > LAN IP > Add Rule/Edit
LABEL DESCRIPTION
Device LIst This field lists the system name of the LAN user device which is connected to the
NBG6818 and assigned an IP address.
Select a LAN user device from the list to automatically detect the MAC address of a
computer on your LAN.
Otherwise, select User-Defined to enter the MAC address of a computer on your
LAN in the MAC Address field.
MAC Address This field displays the MAC address of a computer on your LAN. If you select User-
Defined in the Device List field, enter the MAC address(es) manually.
IP Address This field displays the IP address of a computer on your LAN. If you select User-
Defined in the Device List field, enter the IP address(es) manually.
Apply Click Apply to save your changes back to the NBG6818.
Cancel Click Cancel to exit this screen without saving.