User Manual
Table Of Contents
- ARMOR G1
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG6818 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG6818’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG6818’s LED (Light)
- 7.9 Change Your NBG6818 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 10 Wireless LAN
NBG6818 User’s Guide
112
10.6 Scheduling Screen
Use this screen to set the times your wireless LAN is turned on and off. Wireless LAN scheduling is disabled
by default. The wireless LAN can be scheduled to turn on or off on certain days and at certain times. The
y-axis shows the time period in days. The x-axis shows the time period in hours. Click on the boxes to
select the time period.
Click Settings > WiFi > Scheduling to show the following screen.
Figure 63 Settings > WiFi > Scheduling
The following table describes the labels in this screen.
Table 37 Expert Mode > Wireless > Scheduling
LABEL DESCRIPTION
WiFi Scheduling Select Enable to activate the wireless LAN scheduling feature. Select Disable to turn it off.
Select All Click Select All or click gray blocks to specify days and times to turn the Wireless LAN on or
off. If you click Select All you can not select any specific days and times.
Deselect All Click Deselect All to remove all the wireless LAN scheduling.
Apply Click Apply to save your changes back to the NBG6818.
Cancel Click Cancel to reload the previous configuration for this screen.