User Manual
Table Of Contents
- ARMOR G1
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG6818 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG6818’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG6818’s LED (Light)
- 7.9 Change Your NBG6818 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 10 Wireless LAN
NBG6818 User’s Guide
110
Figure 61 Settings > WiFi > MAC Filter > Add
The following table describes the labels in this screen.
10.5 WPS Screen
Use this screen to enable/disable WPS, view or generate a new PIN and check the current WPS status.
Click Settings > WiFi > WPS to show the following screen.
Note: With WPS, wireless clients can only connect to the wireless network using the first SSID on
the NBG6818.
Table 35 Settings > WiFi > MAC Filter > Add
LABEL DESCRIPTION
Type This field displays the MAC address of the wireless station. If you select User-Defined,
enter the MAC address(es) manually.
MAC Address Enter a MAC address manually in this field if you select User-Defined in the Type field.
Apply Click Apply to save your changes back to the NBG6818.
Cancel Click Cancel to exist this screen without saving.