User Manual
Table Of Contents
- ARMOR G1
- User’s Guide
- Introduction
- Wizard
- The Web Configurator
- NBG6818 Modes
- Standard Mode
- Bridge Mode
- Tutorials
- 7.1 Overview
- 7.2 Run a Speed Test
- 7.3 Configure the NBG6818’s WiFi Networks
- 7.4 Enable or Disable a WiFi Network
- 7.5 Add Clients to a Profile
- 7.6 Set a Profile’s WiFi Schedule
- 7.7 Pause or Resume Internet Access on a Profile
- 7.8 Turn on or off the NBG6818’s LED (Light)
- 7.9 Change Your NBG6818 Operating Mode
- 7.10 Configure a Port Forwarding Rule
- Technical Reference
- Applications
- WAN
- Wireless LAN
- LAN
- Security
- System
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 10 Wireless LAN
NBG6818 User’s Guide
108
10.3 Guest WiFi Screen
This screen allows you to enable and configure guest wireless network settings on the NBG6818.
Click Settings > WiFi > Guest WiFi to show the following screen.
Note: This is not available if you are using bridge mode.
Figure 59 Settings > WiFi > Guest WiFi
The following table describes the labels in this screen.
10.4 MAC Filter Screen
The MAC filter screen allows you to give exclusive access to devices (Allow) or exclude devices from
accessing the NBG6818 (Deny). Every Ethernet device has a unique MAC (Media Access Control)
address. The MAC address is assigned at the factory and consists of six pairs of hexadecimal characters,
Table 33 Settings > WiFi > Guest WiFi
LABEL DESCRIPTION
Enable Guest
WiFi
Select Enable to activate the guest WiFi. Select Disable to turn it off.
Name (SSID) An SSID profile is the set of parameters relating to one of the NBG6818’s BSSs. The SSID (Service
Set IDentifier) identifies the Service Set with which a wireless device is associated.
This field displays the name of the wireless profile on the network. When a wireless client scans
for an AP to associate with, this is the name that is broadcast and seen in the wireless client
utility.
Password The password has two uses.
• Manual: Manually enter the same password on the Zyxel Device and the client. Enter 8-63
ASCII characters or exactly 64 hexadecimal (‘0-9’, ‘a-f’) characters.
• WPS: When using WPS, the Zyxel Device sends this password to the client.
Click the Eye icon to show or hide the password of your wireless network. When the Eye icon
is slashed , you’ll see the password in plain text. Otherwise, it is hidden.
Apply Click Apply to save your changes back to the NBG6818.
Cancel Click Cancel to reload the previous configuration for this screen.