Instructions

Chapter 10 Wireless LAN

NBG6604 User’s Guide

Figure 43 Wireless > Guest Wireless > Guest Wireless Setup: Edit

The following table describes the labels in this screen.

Table 25 Wireless > Guest Wireless > Guest Wireless Setup: Edit

LABEL DESCRIPTION

Active Select this to activate the SSID profile.

Name (SSID) The SSID (Service Set IDentity) identifies the Service Set with which a wireless client is associated.

Enter a descriptive name (up to 32 printable characters found on a typical English language

keyboard) for the wireless LAN.

Hide SSID Select this check box to hide the SSID in the outgoing beacon frame so a station cannot obtain

the SSID through scanning using a site survey tool.

Intra-BSS Traffic

Blocking

A Basic Service Set (BSS) exists when all communications between wireless clients or between a

wireless client and a wired network client go through one access point (AP).

Intra-BSS traffic is traffic between wireless clients in the BSS. When Intra-BSS is enabled, wireless

clients can access the wired network and communicate with each other. When Intra-BSS is

disabled, wireless clients can still access the wired network but cannot communicate with each

other.

WMM QoS Check this to have the NBG6604 automatically give a service a priority level according to the

ToS value in the IP header of packets it sends.

WMM QoS (Wifi MultiMedia Quality of Service) gives high priority to voice and video, which

makes them run more smoothly.

Maximum

Bandwidth

Enter a number to specify maximum bandwidth the Guest Wi-Fi network can use.

Security Mode Select WPA-PSK or WPA2-PSK to add security on this wireless network. The wireless clients which

want to associate to this network must have same wireless security settings as this device. After

you select to use a security, additional options appears in this screen. See

Section 10.3 on page

70 for detailed information on different security modes. Or you can select No Security to allow

any client to associate this network without authentication.

Note: If the WPS function is enabled (default), only No Security and WPA2-PSK are

available in this field.

Apply Click Apply to save your changes back to the NBG6604.

Cancel Click Cancel to reload the previous configuration for this screen.