Instructions

Chapter 6 Access Point Mode
NBG6604 User’s Guide
32
6.3.1 Setting your NBG6604 to AP Mode
1 Log into the Web Configurator if you haven’t already. See Section 2.2 on page 14 for how to do this.
2 To use your NBG6604 as an access point, go to Maintenance > Operation Mode and select Access Point
Mode.
Figure 19 Changing to Access Point Mode
Note: You have to log in to the Web Configurator again when you change modes. As soon as
you do, your NBG6604 is already in Access Point mode.
3 When you select Access Point Mode, the following pop-up message window appears:
Figure 20 Pop up for Access Point Mode
Click OK. Then click Apply. The Web Configurator refreshes once the change to Access Point mode is
successful.
6.3.2 Accessing the Web Configurator in Access Point Mode
To log into the Web Configurator in Access Point mode, do the following:
1 Connect your computer to the LAN port of the NBG6604.
2 The default IP address of the NBG6604 is “192.168.1.2”. In this case, your computer must have an IP
address in the range between “192.168.1.3” and “192.168.1.254”.
3 Click Start > Run on your computer in Windows. Type “cmd” in the dialog box. Enter “ipconfig” to show
your computer’s IP address. If your computer’s IP address is not in the correct range then see
Appendix
B on page 113 for information on changing your computer’s IP address.
4 After you’ve set your computer’s IP address, open a web browser such as Internet Explorer and type
“192.168.1.2” as the web address in your web browser.