Instructions

Chapter 5 Router Mode
NBG6604 User’s Guide
29
Figure 17 Navigation Panel: Router Mode
The following table describes the sub-menus.
Table 10 Navigation Panel: Router Mode
LINK FUNCTION
Status
System Status This screen shows the NBG6604’s general device, system and interface status information. Use
this screen to access the wizard, and summary statistics tables.
Client Tables Use this screen to view current DHCP client information.
WAN
Internet
Connection
This screen allows you to configure ISP parameters, WAN IP address assignment, DNS servers
and the WAN MAC address.
NAT Use this screen to enable NAT.
Use this screen to configure servers behind the NBG6604 and forward incoming service
requests to the server(s) on your local network.
Use this screen to change your NBG6604’s port triggering settings.
Use this screen to configure VPN pass-through settings.
Dynamic DNS Use this screen to set up dynamic DNS.
Wireless
Wireless Use this screen to enable the wireless LAN and configure wireless LAN and wireless security
settings.
Guest Wireless Use this screen to configure multiple BSSs on the NBG6604.
MAC Filter Use the MAC filter screen to configure the NBG6604 to block access to devices or block the
devices from accessing the NBG6604.
Advanced This screen allows you to configure advanced wireless settings.
WPS Use this screen to configure WPS.
Scheduling Use this screen to schedule the times the Wireless LAN is enabled.
LAN
LAN IP Use this screen to configure LAN IP address and subnet mask.
Use this screen to enable the NBG6604’s DHCP server.
Static DHCP This screen allows you to assign IP addresses on the LAN to specific individual computers based
on their MAC addresses.
Applications
UPnP Use this screen to enable UPnP on the NBG6604.
One Connect Use this screen to enable or disable Wi-Fi auto-configuration.
Security