Operation Manual

Chapter 4 AP Mode
NBG334S User’s Guide
65
4.4 Configuring Your Settings
4.4.1 LAN Settings
Use this section to configure your LAN settings while in AP Mode.
Click Network > LAN to see the screen below.
" If you change the IP address of the NBG334S in the screen below, you will
need to log into the NBG334S again using the new IP address.
Figure 32 Network > LAN > IP
LAN IP Use this screen to configure LAN IP address and subnet mask or to
get the LAN IP address from a DHCP server.
Maintenance
System General Use this screen to view and change administrative settings such as
system and domain names, password and inactivity timer.
Time Setting Use this screen to change your NBG334S’s time and date.
Logs View Log Use this screen to view the logs for the categories that you
selected.
Log Settings Use this screen to change your NBG334S’s log settings.
To o l s Firmware Use this screen to upload firmware to your NBG334S.
Configuration Use this screen to backup and restore the configuration or reset
the factory defaults to your NBG334S.
Restart This screen allows you to reboot the NBG334S without turning the
power off.
Config Mode General This screen allows you to display or hide the advanced screens or
features.
Sys OP
Mode
General This screen allows you to select whether your device acts as a
Router or a Access Point.
Language Language This screen allows you to change the language the web
configurator uses.
Table 23 Screens Summary
LINK TAB FUNCTION