Operation Manual

Chapter 2 Introducing the Web Configurator
NBG334S User’s Guide
40
2.5.2 Summary: Any IP Table
This screen displays the IP address of each computer that is using the NBG334S via the any IP
feature. Any IP allows computers to access the Internet through the NBG334S without
changing their network settings when NAT is enabled. To access this screen, open the Status
screen (see Section 2.5 on page 35), and click (Details...) next to Any IP Table.
Figure 6 Any IP Table
2.5.3 Summary: Bandwidth Management Monitor
Select the BW MGMT Monitor (Details...) hyperlink in Status screen. View the bandwidth
usage of the WAN configured bandwidth rules. This is also shown as bandwidth usage over
the bandwidth budget for each rule. The gray section of the bar represents the percentage of
unused bandwidth and the blue color represents the percentage of bandwidth in use.
Figure 7 Summary: BW MGMT Monitor
To o l s Firmware Use this screen to upload firmware to your NBG334S.
Configuration Use this screen to backup and restore the configuration or reset
the factory defaults to your NBG334S.
Restart This screen allows you to reboot the NBG334S without turning the
power off.
Config Mode General This screen allows you to display or hide the advanced screens or
features.
Sys OP
Mode
General This screen allows you to select whether your device acts as a
Router or a Access Point.
Language Language This screen allows you to change the language the web
configurator uses
Table 5 Screens Summary
LINK TAB FUNCTION