Operation Manual

Chapter 2 Introducing the Web Configurator
NBG334S User’s Guide
35
Click Go to Advanced Setup to view and configure all the NBG334S’s settings.
• You can also configure your language settings in Maintenance > Language.
2.3 Resetting the NBG334S
If you forget your password or IP address, or you cannot access the web configurator, you will
need to use the RESET button at the back of the NBG334S to reload the factory-default
configuration file. This means that you will lose all configurations that you had previously
saved, the password will be reset to “1234” and the IP address will be reset to “192.168.1.1”.
2.3.1 Procedure to Use the Reset Button
1 Make sure the power LED is on.
2 Press the RESET button for five seconds or until the power LED begins to blink and
then release it. When the power LED begins to blink, the defaults have been restored and
the NBG334S restarts.
2.4 Navigating the Web Configurator
The following summarizes how to navigate the web configurator from the Status screen in
Router Mode and AP Mode.
2.5 The Status Screen in Router Mode
Click on Status. The screen below shows the status screen in Router Mode.
(For information on the status screen in AP Mode see Chapter 4 on page 62.)