Operation Manual

Appendix A Product Specifications and Wall-Mounting Instructions
NBG334S User’s Guide
214
Wall-mounting Instructions
Do the following to hang your NBG334S on a wall.
" See the Figure 122 on page 215 for the size of screws to use and how far
apart to place them.
1 Locate a high position on a wall that is free of obstructions. Use a sturdy wall.
2 Drill two holes for the screws. Make sure the distance between the centers of the holes
matches what is listed in the product specifications appendix.
1 Be careful to avoid damaging pipes or cables located inside the wall when
drilling holes for the screws.
3 Do not screw the screws all the way into the wall. Leave a small gap of about 0.5 cm
between the heads of the screws and the wall.
4 Make sure the screws are snugly fastened to the wall. They need to hold the weight of
the NBG334S with the connection cables.
5 Align the holes on the back of the NBG334S with the screws on the wall. Hang the
NBG334S on the screws.
IEEE 802.11b Uses the 2.4 gigahertz (GHz) band
IEEE 802.11g Uses the 2.4 gigahertz (GHz) band
IEEE 802.11d Standard for Local and Metropolitan Area Networks: Media Access
Control (MAC) Bridges
IEEE 802.11x Port Based Network Access Control.
IEEE 802.11e QoS IEEE 802.11 e Wireless LAN for Quality of Service
Microsoft PPTP MS PPTP (Microsoft's implementation of Point to Point Tunneling
Protocol)
MBM v2 Media Bandwidth Management v2
Table 98 Standards Supported (continued)
STANDARD DESCRIPTION