Operation Manual

Chapter 8 LAN
NBG334S User’s Guide
106
8.3 LAN IP Screen
Use this screen to change your basic LAN settings. Click Network > LAN.
Figure 56 Network > LAN > IP
The following table describes the labels in this screen.
8.4 LAN IP Alias
IP alias allows you to partition a physical network into different logical networks over the
same Ethernet interface. The NBG334S supports three logical LAN interfaces via its single
physical Ethernet interface with the NBG334S itself as the gateway for each LAN network.
To change your NBG334S’s IP alias settings, click Network > LAN > IP Alias. The screen
appears as shown.
Table 40 Network > LAN > IP
LABEL DESCRIPTION
LAN TCP/IP
IP Address Type the IP address of your NBG334S in dotted decimal notation 192.168.1.1
(factory default).
IP Subnet Mask The subnet mask specifies the network number portion of an IP address. Your
NBG334S will automatically calculate the subnet mask based on the IP address
that you assign. Unless you are implementing subnetting, use the subnet mask
computed by the NBG334S.
Apply Click Apply to save your changes back to the NBG334S.
Reset Click Reset to begin configuring this screen afresh.