User Manual

Chapter 7 WAN
NBG-418N v2 User’s Guide
90
Connection Type Select Co ntinuo us if you do not want the connection to time out.
Select Co nne c tio n on De ma nd if you want to connect for a certain amount of time before
the router automatically disconnects from the PPPoE server. If you select this you will need to
enter the number of minutes in the Idle timeout field.
Select Ma nual if want to make the connection manually.
Connect/
Disconnect
Click Conne c t to establish PPPoE connection to the IPv6 Internet or click Disc onne c t to stop
the connection.
IPv6 DNS Settings
Obtain DNS Server
address
automatically
Click the Obta in DNS se rve r a ddre ss a uto ma tic a lly radio button to get a DNS server address
from your ISP’s server.
Use the following
DNS address
Click Use the fo llo wing DNS a ddre ss radio button to use a fixed DNS address.
Primary/Secondary
DNS Address
Enter the first/second IPv6 DNS server address assigned by the ISP.
Lan IPv6 Address Settings
Enable DHCP-PD Click Enable DHCP- PD (DHCP-Prefix delegation) to allow NBG-418N v2 assign prefixes to
DHCP clients.
LAN IPv6 Address Enter the IPv6 address for the LAN interface in this field.
LAN IPv6 Link-Local
Address
This shows the IPv6 Link-local address in the LAN side. This is used by NBG-418N v2 when
communicating with neighboring devices on the same link. It allows IPv6-capable devices
to communicate with each other in the LAN side.i
Address Autoconfiguration Settings
Enable
Autoconfiguration
Click Enable Autoc onfig uratio n if you want the devices on your local area network to obtain
network address that are not managed by a DHCPv6 server.
Autoconfiguration
Type
Select SLAAC + Sta te le ss DHCPv6 if you want the interface to automatically generate a link-
local address via stateless autoconfiguration.
Select Sta te ful(DHCPv6) when the devices connected to your LAN needs to have their TCP/
IP configuration set to DHCPv6 or obtain an IPv6 address automatically.
Router
Advertisement
Lifetime
If you select SLAAC + Sta te le ss DHCPv6, type in the Route r Adve rtise me nt Life tim e which is
amount of time in minutes that a device may have an IPv6 address before it is required to
renew the lease.
IPv6 Address
Range(Start)
If you select Sta te ful (DHCPv6), specify the range of IPv6 addresses from which the DHCPv6
server assigns to the clients. Enter the smallest value of the last block of the IPv6 addresses
which are to be allocated.
IPv6 Address
Range(End)
If you select Sta te ful (DHCPv6), specify the range of IPv6 addresses from which the DHCPv6
server assigns to the clients. Enter the largest value of the last block of the IPv6 addresses
which are to be allocated.
IPv6 Address
Lifetime
If you select Sta te ful (DHCPv6), specify how long (in minutes) the IPv6 addresses remain
valid.
Apply Click Apply to save your changes back to the NBG-418N v2.
Reset Click Re se t to begin configuring this screen afresh.
Table 39 Network > WAN > IPv6 (continued)(PPPoE)
LABEL DESCRIPTION