User Manual
Table Of Contents
- NBG-418N v2
- User’s Guide
- Introduction
- The Web Configurator
- Connection Wizard
- Modes
- Tutorials
- 5.1 Overview
- 5.2 How to Connect to the Internet from an AP
- 5.3 Configure Wireless Security Using WPS on both your NBG-418N v2 and Wireless Client
- 5.4 Enable and Configure Wireless Security without WPS on your NBG-418N v2
- 5.5 Using Multiple SSIDs on the NBG-418N v2
- 5.6 Installing UPnP in Windows 7 Example
- 5.7 Using Bandwidth Management on the NBG-418N v2
- Technical Reference
- Wireless LAN
- WAN
- LAN
- DHCP Server
- Network Address Translation
- Dynamic DNS
- Static Route
- Firewall
- Content Filter
- Remote Management
- Universal Plug-and-Play (UPnP)
- Bandwidth MGMT
- System
- Logs
- Tools
- Sys OP Mode
- Language
- Troubleshooting
- Customer Support
- IP Addresses and Subnetting
- Pop-up Windows, JavaScripts and Java Permissions
- Setting Up Your Computer’s IP Address
- Wireless LANs
- Common Services
- Legal Information
- Index
Chapter 6 Wireless LAN
NBG-418N v2 User’s Guide
70
Fig ure 49 Network > Wireless LAN > WPS
The following table describes the labels in this screen.
6.8 WPS Sta tion Sc re e n
Use this screen when you want to add a wireless station using WPS. To open this screen, click Ne twork >
Wirele ss LAN > WPS Sta tion tab.
Note: Note: After you click Push Button on this screen, you have to press a similar button in the
wireless station utility within 2 minutes. To add the second wireless station, you have to
press these buttons on both device and the wireless station again after the first 2
minutes.
Table 25 Network > Wireless LAN > WPS
LABEL DESCRIPTION
WPS Setup
Enable WPS Click the Ena ble WPS check box to enable the WPS feature. Click again to disable it.
PIN Number This displays a PIN number last time system generated. Click Ge ne ra te to generate a new PIN
number.
WPS Status
Status This displays Config ured when the NBG-418N v2 has connected to a wireless network using
WPS or when Ena ble WPS is selected and wireless or wireless security settings have been
changed. The current wireless and wireless security settings also appear in the screen.
This displays Unc onfigure d if WPS is disabled and there are no wireless or wireless security
changes on the NBG-418N v2 or you click Re le a se _Configura tio n to remove the configured
wireless and wireless security settings.
Release
Configuration
This button is only available when the WPS status displays C onfig ure d.
Click this button to remove all configured wireless and wireless security settings for WPS
connections on the NBG-418N v2.
Apply Click Apply to save your changes back to the NBG-418N v2.
Refresh Click Re fre sh to get this screen information afresh.