User Manual
Table Of Contents
- NBG-418N v2
- User’s Guide
- Introduction
- The Web Configurator
- Connection Wizard
- Modes
- Tutorials
- 5.1 Overview
- 5.2 How to Connect to the Internet from an AP
- 5.3 Configure Wireless Security Using WPS on both your NBG-418N v2 and Wireless Client
- 5.4 Enable and Configure Wireless Security without WPS on your NBG-418N v2
- 5.5 Using Multiple SSIDs on the NBG-418N v2
- 5.6 Installing UPnP in Windows 7 Example
- 5.7 Using Bandwidth Management on the NBG-418N v2
- Technical Reference
- Wireless LAN
- WAN
- LAN
- DHCP Server
- Network Address Translation
- Dynamic DNS
- Static Route
- Firewall
- Content Filter
- Remote Management
- Universal Plug-and-Play (UPnP)
- Bandwidth MGMT
- System
- Logs
- Tools
- Sys OP Mode
- Language
- Troubleshooting
- Customer Support
- IP Addresses and Subnetting
- Pop-up Windows, JavaScripts and Java Permissions
- Setting Up Your Computer’s IP Address
- Wireless LANs
- Common Services
- Legal Information
- Index
Chapter 6 Wireless LAN
NBG-418N v2 User’s Guide
69
6.6 Wire le ss LAN Adva nc e d Sc re e n
Use this screen to allow intra-BSS networking and set the RTS/CTS Threshold.
Click Ne twork > Wire le ss LAN > Advanc e d. The screen appears as shown.
Fig ure 48 Network > Wireless LAN > Advanced
The following table describes the labels in this screen.
6.7 WPS Sc re e n
Use this screen to enable/disable WPS, view or generate a new PIN number and check current WPS
status. To open this screen, click Ne twork > Wirele ss LAN > WPS tab.
Table 24 Network > Wireless LAN > Advanced
LABEL DESCRIPTIO N
Wireless Advanced Setup
Tx Power This field controls the transmission power of the NBG-418N v2. If there is a high density of APs in
an area, decrease the output power of the NBG-418N v2 to reduce interference with other
APs.
Enable Intra-BSS
Traffic
A Basic Service Set (BSS) exists when all communications between wireless clients or between
a wireless client and a wired network client go through one access point (AP).
Intra-BSS traffic is traffic between wireless clients in the BSS. When Intra-BSS is enabled, wireless
client A and B can access the wired network and communicate with each other. When Intra-
BSS is disabled, wireless client A and B can still access the wired network but cannot
communicate with each other.
Apply Click Apply to save your changes to the NBG-418N v2.
Reset Click Re se t to reload the previous configuration for this screen.