User Manual
Table Of Contents
- NBG-418N v2
- User’s Guide
- Introduction
- The Web Configurator
- Connection Wizard
- Modes
- Tutorials
- 5.1 Overview
- 5.2 How to Connect to the Internet from an AP
- 5.3 Configure Wireless Security Using WPS on both your NBG-418N v2 and Wireless Client
- 5.4 Enable and Configure Wireless Security without WPS on your NBG-418N v2
- 5.5 Using Multiple SSIDs on the NBG-418N v2
- 5.6 Installing UPnP in Windows 7 Example
- 5.7 Using Bandwidth Management on the NBG-418N v2
- Technical Reference
- Wireless LAN
- WAN
- LAN
- DHCP Server
- Network Address Translation
- Dynamic DNS
- Static Route
- Firewall
- Content Filter
- Remote Management
- Universal Plug-and-Play (UPnP)
- Bandwidth MGMT
- System
- Logs
- Tools
- Sys OP Mode
- Language
- Troubleshooting
- Customer Support
- IP Addresses and Subnetting
- Pop-up Windows, JavaScripts and Java Permissions
- Setting Up Your Computer’s IP Address
- Wireless LANs
- Common Services
- Legal Information
- Index
Chapter 6 Wireless LAN
NBG-418N v2 User’s Guide
64
Click Ne twork > Wire le ss LAN to open the G e ne ra l screen.
Fig ure 42 Network > Wireless LAN > General (Router or Access Point Mode)
Fig ure 43 Network > Wireless LAN > General (Universal Repeater Mode)
The following table describes the general wireless LAN labels in this screen.
Table 19 Network > Wireless LAN > General
LABEL DESCRIPTION
WLAN STA
Information
This section is available only when the NBG-418N v2 is in universal repeater mode. This shows the
wireless and security settings of the selected AP wireless network.
SSID This displays the Service Set IDentity of the wireless device to which you are connecting.
Security Mode This displays the type of security configured on the wireless device to which you are connecting.
Operating
Channel
This displays the channel used by the wireless device to which you are connecting.