User Manual
Table Of Contents
- NBG-418N v2
- User’s Guide
- Introduction
- The Web Configurator
- Connection Wizard
- Modes
- Tutorials
- 5.1 Overview
- 5.2 How to Connect to the Internet from an AP
- 5.3 Configure Wireless Security Using WPS on both your NBG-418N v2 and Wireless Client
- 5.4 Enable and Configure Wireless Security without WPS on your NBG-418N v2
- 5.5 Using Multiple SSIDs on the NBG-418N v2
- 5.6 Installing UPnP in Windows 7 Example
- 5.7 Using Bandwidth Management on the NBG-418N v2
- Technical Reference
- Wireless LAN
- WAN
- LAN
- DHCP Server
- Network Address Translation
- Dynamic DNS
- Static Route
- Firewall
- Content Filter
- Remote Management
- Universal Plug-and-Play (UPnP)
- Bandwidth MGMT
- System
- Logs
- Tools
- Sys OP Mode
- Language
- Troubleshooting
- Customer Support
- IP Addresses and Subnetting
- Pop-up Windows, JavaScripts and Java Permissions
- Setting Up Your Computer’s IP Address
- Wireless LANs
- Common Services
- Legal Information
- Index
Chapter 5 Tutorials
NBG-418N v2 User’s Guide
58
2 Go to Mana g e me nt > Ba ndwidth MGMT > Adva nc e d and enter 819200 in the Tota l Up Stre a m and Down
Stre a m Bandwidth fields in the Q oS Se tup section. It is recommended to set this number to match the
actual upstream data rate. Click Apply or Re se t to clear the fields.
3 Then, Click Add in the QoS Rule s section and several box fields appears. Enter 192.168.1.10 in the Sourc e
IP fie ld, 192.168.1.10/32 will appear in the field, the 32-bits network is IPv4 addresses block that is assigned
by your ISP. Next, enter 150000 for Up Ce ling field and 600000 for Down Ce iling field and click Add. Note
that the Up/Down Ceiling numbers should not exceed the Total Bandwidth. You have successfully set a
specific minimum and maximum bandwidth for this particular IP address.
4 If you wish to delete a QoS Rules entry, click the De le te check box of the rule and click De le te button. To
clear the Source IP, Up/Down Ceiling box fields, click Re se t button.