User Manual
Table Of Contents
- NBG-418N v2
- User’s Guide
- Introduction
- The Web Configurator
- Connection Wizard
- Modes
- Tutorials
- 5.1 Overview
- 5.2 How to Connect to the Internet from an AP
- 5.3 Configure Wireless Security Using WPS on both your NBG-418N v2 and Wireless Client
- 5.4 Enable and Configure Wireless Security without WPS on your NBG-418N v2
- 5.5 Using Multiple SSIDs on the NBG-418N v2
- 5.6 Installing UPnP in Windows 7 Example
- 5.7 Using Bandwidth Management on the NBG-418N v2
- Technical Reference
- Wireless LAN
- WAN
- LAN
- DHCP Server
- Network Address Translation
- Dynamic DNS
- Static Route
- Firewall
- Content Filter
- Remote Management
- Universal Plug-and-Play (UPnP)
- Bandwidth MGMT
- System
- Logs
- Tools
- Sys OP Mode
- Language
- Troubleshooting
- Customer Support
- IP Addresses and Subnetting
- Pop-up Windows, JavaScripts and Java Permissions
- Setting Up Your Computer’s IP Address
- Wireless LANs
- Common Services
- Legal Information
- Index
Chapter 5 Tutorials
NBG-418N v2 User’s Guide
57
5.6 Insta lling UPnP in Windows 7 Exa mple
For more information on how to install Universal Plug and Play in Windows on your computer, see
Section
16.4 on page 126
5.7 Using Ba ndwidth Ma na g e me nt on the NBG- 418N v2
Bandwidth management provides a convenient way to manage the use of various services on the
network. It manages general protocols (for example, HTTP and FTP) and applies traffic prioritization to
enhance the performance of delay-sensitive applications like voice and video.
In the figure below, uplink traffic goes from the LAN device (A) to the WAN device (B). Bandwidth
management is applied before sending the packets out to the WAN. Downlink traffic comes back from
the WAN device (B) to the LAN device (A). Bandwidth management is applied before sending the
traffic out to LAN.
Fig ure 40 Bandwidth Management Example
You can allocate specific amounts of bandwidth capacity (bandwidth budgets) to individual
applications (like VoIP, Web, FTP, and E-mail for example).
This example shows you how to configure the Bandwidth Management with the following parameters
on your NBG-418N v2 (in router mode).
QoS Rule
1 Go to Ma na g e me nt > Bandwidth MGMT > Bandwidth MGMT and click Enable Bandwidth Management
check box.
UP Stream 819200 kpbs
Down Stream 819200 kbps
Source IP 192.168.1.10
Up Ceiling 150000 kb/s
Down Ceiling 600000 kb/s
A
B
-> VoIP
-> FTP
-> HTTP
-> Chat, E-QoSmail