User Manual
Table Of Contents
- NBG-418N v2
- User’s Guide
- Introduction
- The Web Configurator
- Connection Wizard
- Modes
- Tutorials
- 5.1 Overview
- 5.2 How to Connect to the Internet from an AP
- 5.3 Configure Wireless Security Using WPS on both your NBG-418N v2 and Wireless Client
- 5.4 Enable and Configure Wireless Security without WPS on your NBG-418N v2
- 5.5 Using Multiple SSIDs on the NBG-418N v2
- 5.6 Installing UPnP in Windows 7 Example
- 5.7 Using Bandwidth Management on the NBG-418N v2
- Technical Reference
- Wireless LAN
- WAN
- LAN
- DHCP Server
- Network Address Translation
- Dynamic DNS
- Static Route
- Firewall
- Content Filter
- Remote Management
- Universal Plug-and-Play (UPnP)
- Bandwidth MGMT
- System
- Logs
- Tools
- Sys OP Mode
- Language
- Troubleshooting
- Customer Support
- IP Addresses and Subnetting
- Pop-up Windows, JavaScripts and Java Permissions
- Setting Up Your Computer’s IP Address
- Wireless LANs
- Common Services
- Legal Information
- Index
Chapter 5 Tutorials
NBG-418N v2 User’s Guide
47
• PIN Config uration - create a secure wireless network simply by entering a wireless client's PIN (Personal
Identification Number) in the NBG-418N v2’s interface. See
Section 5.3.2 on page 48. This is the more
secure method, since one device can authenticate the other.
5.3.1 Push Button Configuration (PBC)
1 Make sure that your NBG-418N v2 is turned on and that it is within range of your computer.
2 Make sure that you have installed the wireless client (this example uses the NWD210N) driver and utility in
your notebook.
3 In the wireless client utility, find the WPS settings. Enable WPS and press the WPS button (Sta rt or WPS
button)
4 Log into NBG-418N v2’s Web Configurator and press Push Button in the Ne twork > Wirele ss LAN > WPS
Sta tion screen.
Note: Your NBG-418N v2 has a WPS/RESET button located on its back panel, as well as a WPS
button in its configuration utility. Both buttons have exactly the same function; you can
use one or the other.
Note: It doesn’t matter which button is pressed first. You must press the second button within
two minutes of pressing the first one.
The NBG-418N v2 sends the proper configuration settings to the wireless client. This may take up to two
minutes. Then the wireless client is able to communicate with the NBG-418N v2 securely.
The following figure shows you an example to set up wireless network and security by pressing a button
on both NBG-418N v2 and wireless client (the NWD210N in this example).