User Manual
Table Of Contents
- NBG-418N v2
- User’s Guide
- Introduction
- The Web Configurator
- Connection Wizard
- Modes
- Tutorials
- 5.1 Overview
- 5.2 How to Connect to the Internet from an AP
- 5.3 Configure Wireless Security Using WPS on both your NBG-418N v2 and Wireless Client
- 5.4 Enable and Configure Wireless Security without WPS on your NBG-418N v2
- 5.5 Using Multiple SSIDs on the NBG-418N v2
- 5.6 Installing UPnP in Windows 7 Example
- 5.7 Using Bandwidth Management on the NBG-418N v2
- Technical Reference
- Wireless LAN
- WAN
- LAN
- DHCP Server
- Network Address Translation
- Dynamic DNS
- Static Route
- Firewall
- Content Filter
- Remote Management
- Universal Plug-and-Play (UPnP)
- Bandwidth MGMT
- System
- Logs
- Tools
- Sys OP Mode
- Language
- Troubleshooting
- Customer Support
- IP Addresses and Subnetting
- Pop-up Windows, JavaScripts and Java Permissions
- Setting Up Your Computer’s IP Address
- Wireless LANs
- Common Services
- Legal Information
- Index
Chapter 4 Modes
NBG-418N v2 User’s Guide
43
6 A pop-up window appears providing information on this mode. Click OK in the pop-up message
window. Click Apply. Your NBG-418N v2 is now in Clie nt Bridg e mode.
Note: Wait while the NBG-418N v2 restarts, then log in to the Web Configurator again.
4.5.1 Sta tus Sc re e n (Clie nt Bridge Mode )
Click on Sta tus. The screen below shows the status screen in Clie nt Bridg e mode.
Fig ure 29 Status Screen (Client Bridge Mode)
The following table describes the labels shown in the Status screen.
Table 16 Status Screen (Client Bridge Mode)
LABEL DESCRIPTION
Device Information
System Name This is the Syste m Na me you enter in the Ma inte na nc e > Syste m > Ge ne ra l screen.
It is for identification purposes.